Materials incorporated by reference.

CFR · 2024-01-01 · US · Title 10

(a) Certain material is incorporated by reference into this subpart with the approval of the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. To enforce any edition other than that specified in this section, the DOE must publish a document in the (b) (1) ANSI/ASHRAE Standard 118.1-2012, “Method of Testing for Rating Commercial Gas, Electric, and Oil Service Water-Heating Equipment,” approved by ASHRAE on October 26, 2012, IBR approved for appendix E to this subpart, as follows: (i) Section 3—Definitions and Symbols; (ii) Section 4—Classifications by Mode of Operation (sections 4.4, and 4.5 only); (iii) Section 6—Instruments (except sections 6.3, 6.4 and 6.6); (iv) Section 7—Apparatus (except section 7.4, Figures 1 through 4, section 7.7.5, Table 2, and section 7.7.7.4); (v) Section 8—Methods of Testing: (A) Section 8.2—Energy Supply, Section 8.2.1—Electrical Supply; (B) Section 8.7—Water Temperature Control; (vi) Section 9—Test Procedures: 9.1—Input Rating, Heating Capacity, Thermal Efficiency, Coefficient of Performance (COP), and Recovery Rating; 9.1.1—Full Input Rating; (vii) Section 10—Calculation of Results: Section 10.3—Heat-Pump Water Heater Water-Heating Capacity, Coefficient of Performance (COP), and Recovery Rating; Section 10.3.1—Type IV and Type V Full-Capacity Test Method. (2) [Reserved] (c) (1) ASTM C177-13, “Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guar

official document · source cfr-2024 · id 10:§ 431.105