Demonstration of static longitudinal stability.

CFR · 2024-01-01 · US · Title 14

Static longitudinal stability must be shown as follows: (a) (1) Is trimmed, with— (i) Wing flaps retracted; (ii) Landing gear retracted; (iii) Maximum takeoff weight; and (iv) 75 percent of maximum continuous power for reciprocating engines or the maximum power or thrust selected by the applicant as an operating limitation for use during climb for turbine engines; and (2) Is trimmed at the speed for best rate-of-climb except that the speed need not be less than 1.3 (b) (1) With the landing gear retracted at high speed, the stick force curve must have a stable slope at all speeds within a range which is the greater of 15 percent of the trim speed plus the resulting free return speed range, or 50 knots plus the resulting free return speed range, above and below the trim speed (except that the speed range need not include speeds less than 1.3 (i) The wing flaps retracted; (ii) The center of gravity in the most adverse position (see § 25.27); (iii) The most critical weight between the maximum takeoff and maximum landing weights; (iv) 75 percent of maximum continuous power for reciprocating engines or for turbine engines, the maximum cruising power selected by the applicant as an operating limitation (see § 25.1521), except that the power need not exceed that required at (v) The airplane trimmed for level flight with the power required in paragraph (b)(1)(iv) of this section. (2) With the landing gear retracted at low speed, the stick force curve must have a stable slope at all sp

official document · source cfr-2024 · id 14:§ 25.175